 |
 |
 |
 |
 |
 |
 |
 |
 |
GTT
Product Range
Select
Here:
EXTERIOR STYLING
GT Tuning have designed and manufactured
a wide range of modern, highest quality styling parts. All our glass fibre
products are of a higher quality than normally found, which means less
finishing required. Our products require typically half the time for final
preparation, saving substantially on 'body shop' bills, therefore offering
exceptional value. Our fabricated S316 polished stainless steel products
feature the very best engineering, quality, design flair and ease of fit.
Most require no paintwork after fitting, and their finish will never tarnish,
even at the bottom of the ocean S316 is a marine grade stainless steel!
| GTT
'Evo' Front Bumper (ES124) Big jap touring car theme, aggressive triangular side vents and huge opening in front allowing excellent cooling big enough to gobble up anything in its path! Lower edge is brought forward and down slightly. Fit is excellent. Where others use two self tapping screws to hold their bumpers on we use 6 x 8 mm studs with full adjustability from left to right and tilt to ensure it aligns perfectly with the other panels and arches. Provision is made for the fitting of either the standard Phase 2 foglights or clear versions of these, up to 3 elliptical vents and GTT 2 piece alloy splitters. (See photos of B5 GTT) £299 + VAT |
||
|
GTT Evo 'RS' Front Bumper (ES125) Through popular request we now produce a second version of the above featuring large round spotlights in place of the original size rectangular ones. Thus further enhancing the jap theme and even more 'in your face' style. Price is the same but obviously you will require the round lights which are available from us. (See photos of B9 GTT) £299 + VAT |
 |
|
|
NEW GTT Evo Bonnet (ES126) Lightweight glass fibre racing bonnet, built-in twin vents. Based on Mitsubishi EVO 6 rally car. P.O.A. |
||
| GTT
Roof Spoiler (ES127) The spoiler will fit all GT Turbos. This product is designed for simple DIY fitting and, importantly, can be painted off the car. The spoiler follows all the original curves of the vehicle but is spaced away slightly, improving appearance and is particularly stunning on lowered vehicles. It enhances the original lines of the vehicle to give an up to date look without overkill. Fixings are provided. Brake light to mount to the underside of the spoiler also available. £149 + VAT |
 |
|
| GTT
Body Gills (ES128) These are supplied as a set of six for all Phase II cars. It gives a subtle Ferrari Testarrossa feel to the car¹s rear quarter, giving the impression of slightly flared out arches. It also gives you the ultimate excuse to remove the original GT Turbo stickers from the car! The recesses along each gill can be painted in a contrasting colour to further hi-light the effect. £129 + VAT |
 |
|
| GTT
R19 Style Front Grille (ES129) The classic grille! Always popular. The centre 'web' features a recess for the badge to be fitted (not included). Itís more sturdy than others we have seen beware of cheap plastic variety. £65 + VAT |
||
| GTT
Open Grille (ES130) 'The GT Tuning Grille'. Even more modern design and even better cooling. One large big opening looks particularly good with our Evo 'R' bumper. (See B5 & B9 GTT) £69 + VAT |
||
| GTT
'Twister' Front Grille (ES136) Brand new front grille for Summer 2000. A funky little number that oozes even more style than our 'open grille'?? Exceptional quality! £69 + VAT |
 |
|
| Meshes
for above (ES131) (1) Gold anodised aluminium, diamond pattern or (2) Highly polished stainless steel termite mesh with 11mm perforated hole design. Looks good if using our cybercooler and Evo 'R' bumper. Available for all GTT front grills and GTT bumpers. P.O.A. |
||
| GTT
2 piece Alloy Front Splitter (ES132) Similar to that used on many touring cars, with turned up ends for improved looks. Complete with all fixings. Machined slots allow adjustment forward and backward to individual preference. The slots will allow the splitter to slide back up to 50mm allowing a 'safety net' should a kerb be nudged gently, guaranteed unbreakable. It looks good on a standard bumper or GTT Evo 'R'. Alloy spacer blocks are also available to move the splitters down further. £85 + VAT |
||
| GTT
M3 Style Door Mirrors (pair) (ES133) Add bucket loads of style, based on the BMW M3 design. Slightly smaller than others, but in proportion to the car. They come complete with mirror glass and retain the internal joystick adjustment. Miniature clear side repeaters to mount in these mirrors also available. £179 + VAT per pair |
 |
|
| GTT
Elliptical Air Vent (ES135) Another GT Tuning trademark (according to Max Power). Quite simply because so many cars out there wear them. Functional, stylish, inexpensive and easy to fit a winning combination. Additional cooling to intercooler or radiator. Made from highly polished stainless steel (approx. 160mm x 60mm), they fit into cut-outs made in the front bumper in line with the lower section of the radiator and intercooler. The air ducts have a mesh behind them for protection and are recessed to improve the appearance. One, two or three could be used. They also fit many other cars! £35 + VAT |
 |
|
| GTT
Rear Valance Tail Pipe Surround (ES134) Designed to improve looks and prevent the inevitable knocking experienced when using 4" diameter tail pipes. Fabricated entirely from stainless steel and then highly polished. It is designed to fit in and around the edge of the rear valance cut-out, giving a neat and practical solution to the problem. Slight enlargement of the cut-outs is required, but is extremely easy to perform as the valance is made of fibreglass. Accuracy is not important as the cut edges are completely covered by the surrounds face and 50mm deep return lip. £35 + VAT |
 |
|
| Dummy
Twin 4" Tailpipes (ES136) Not to be confused with our twin centre exit 4" exhaust. This product is, in effect, a GTT tailpipe surround combined with a 4" diameter tailpipe (not silencer), that can be fitted in a cut-out made on the right hand side of the rear bumper. They give the impression of left hand and right hand matching exhausts. The tailpipe is adjustable in and out, and up and down to allow it to protrude exactly the same amount as the genuine exhaust pipe on the left hand side. £55 + VAT |
 |
|
|
GTT 'Chrome finish' Stealth Bonnet Vent. (ES137) Styling for the Millennium no bonnet painting required! One or two can be fitted. Aids cooling, looks wicked. An engineering nightmare but we did it! £79 + VAT |
 |
|
| Single
Wiper Conversion kit (ES138) Includes facility to 'centre vertical' park the wiper. Includes additional GTT clamp and bracket to improve anchorage and give smoother operation. £115 + VAT |
 |
|
|
GTT 'Shark's Fin' Sill Wraps (ES138) Easy to fit, stylish and inexpensive! The polished stainless steel fins wrap around the rearmost end of the sill covers enhancing the lines of the vehicle. Side on profile, they are shaped like a shark's dorsal fin (hence the name). They are secured to the vehicle using three self tapping screws on the underside of the sill cover. Fitting time is about ten minutes each. Destined to become as popular as our elliptical vent (we hope). £39 + VAT per pair. |
 |
|
|
GTT Stainless Steel Sill Protectors (ES139) |
 |
|
| Custom
Wheels Due to the vast range available, please let us quote you on your choice of wheel / tyre package. Remember, we can customise many designs of wheels to give your car total individuality e.g. bolts around the circumference, different centre caps, cut-outs, in fact anything that can be cost effectively milled or turned without causing any structural or other problems. See the modified Venoms on B5 GTT . |
 |
|
| Full
Body Kits Imported direct from France, these are the original quality bodykits which offer better fit and finish than the 'UK' copies available elsewhere. Please telephone for more details and prices. |
||
Clear Front Indicators (pair) (ES140) |
||
| Light
Smoke Front Indicators (ES141) As above with smoked (legal) lenses. Looks particularly good on very dark cars. £55 + VAT per pair |
||
| Clear
Side Repeaters (ES142) Two styles available, 'Teardrop' and 'Wedge'. Both types will require enlargement of the original holes in the wing, which, when done, allows the unit to clip properly into place. No paintwork is necessary, as the indicator fully covers the original hole!. Orange bulbs also available for legality. £29 + VAT per pair |
||
| Direct
Replacement Clear Side Repeaters (ES143) Of original design and shape, no modifications required to fit. per pair £35 + VAT |
||
| Clear
Front Fog Lights Phase 2 (pair) (ES144) Highest quality French units, identical to the original yellow items in design. Also includes the black frame around the lens beware of inferior quality units. Phase 1 clears also in stock. £69 + VAT per pair |
 |
|
| Round
Driving Spotlights (ES145) For use in the new Evo RS bumper. £25 + VAT per pair |
||
| Twin
Round Rear Light Conversion (ES146) Fiat Coupe style. Available with conventional colour lenses, though other colours i.e. blue, clear etc will be available for show use in the future. P.O.A. |
||
|
Clear Rear Light Clusters (ES147) (Sorry, not yet available) |
 |
|
| Slimline
L.E.D. Brake Light (ES148) Suitable for mounting on the underside of the GTT Spoiler. £29 + VAT |
||
| Twin
Headlight Conversion (ES149) Kits includes 4 round light units, covers and fitting kit. £269 + VAT |
||